Effects evaluation of remaining resin removal (three modes) on enamel surface after bracket debonding

Karine MACIESKI, Roberto ROCHA, Arno LOCKS, Gerson Ulema RIBEIRO

Introduction: An appropriate selection of instruments is essential to perform a correct debonding technique, by properly removing orthodontic brackets and the remaining resin. Objective: The aim of this study was to evaluate three methods of remaining resin removal on enamel surface after bracket debonding, by means of Scanning Electron Microscopy (SEM). Methods: Eighteen bovine incisors were selected and divided into three groups (A, B and C) of six teeth each. Before bracket bonding, epoxy resin casts were obtained by impression of the teeth with addition silicon, in order to register baseline enamel characteristics and representing the control group. The methods for remaining resin removal were: Group A – gross and medium granulation Soflex discs; Group B – carbide bur in low-speed; Group C – carbide bur in high-speed. Soflex polishing system fine and ultrafine granulation discs were used for Group A, rubber tips for Groups B and C, and polishing paste for all groups. After polishing, impression of teeth were taken and casts were analyzed by means of SEM. The baseline enamel characteristics (Control Group) were compared to the final aspect of enamel to determine the method that generated less enamel abrasion. Results and conclusion: The remaining resin removal by carbide bur in low-rotation, and enamel polished with rubber tips followed by polishing paste produced the smaller damage to the enamel.

Keywords: Dental enamel. Bracket. Debonding.

How to cite: Macieski K, Rocha R, Locks A, Ribeiro GU. Avaliação dos efeitos de três métodos de remoção da resina remanescente do braquete na superfície do esmalte. Dental Press J Orthod. 2011 Sept-Oct;16(5):146-54.

Friday, December 27, 2024 13:38